During the working of welding welder should keep some points
in mind for safety.
1. For best control of your weld bead, keep the wire
directed at the leading edge of the weld pool.
2. When welding out of position (vertical, horizontal, or
overhead welding), keep the weld pool small for best weld bead control, and use
the smallest wire diameter size you can.
3. be sure to match your contact tube, gun liner, and drive
rolls to the wire size you are using.
4. Clean the gun liner and drive rolls occasionally, and
keep the gun nozzle clean of spatter. Replace the contact tip if blocked or
feeding poorly.
5. Keep the gun straight as possible when welding, to avoid
poor wire feeding.
6. Use both hands to steady the gun when you weld. Do this
whenever possible. (This also applies to Stick and TIG welding, and plasma
cutting.)
7. Keep wire feeder hub tension and drive roll pressure just
tight enough to feed wire, but don't over tighten.
8. To avoid picking up contaminants that lead to poor welds?
Keep wire in a clean, dry place when not welding,
9. Use DCEP (reverse polarity) on the power source.
Ador Welding
Academy provides a document for
reading. It is good for welder. They take precautions during practical
training. Know more about Ador Welding
Academy at adorweldingacademy.com.
